How to Enable Peer Verification for a Parameter in Your Prototype ?

Enable peer verification on a parameter by navigating through the parameter's setup options.

1. Log into the system and open your prototype. 
   
   
2. Navigate to the parameter you wish to configure.  
    
3. Click on the edit icon beside the parameter to open its settings.
     
4. In the settings, navigate to the 'Setup' tab. 
   
5. Locate the checkbox labeled 'peer-verification' and select it. 
   
6. Click on the 'Next' button to proceed.    
7. Save your changes by clicking on the 'Save' button.
   
8. To verify, hover over the parameter and click on the edit icon again.
   
9. Navigate back to the 'Setup' tab to ensure the 'peer-verification' is enabled.